Article ID : S500031105 / Last Modified : 11/04/2018

How to create a slide show with PictureGear?

Applicable Products and Categories of This Article

How to create a slide show with PictureGear?

Follow the steps below to create a slide show in the respective PictureGear versions:
* For PictureGear Version 3.2 and earlier
1. Start PictureGear.
2. From the Properties menu, click Slide Show.
3. Click Control, Size and Control Bar to set the effect on the slide show. (The settings of image effects and sound effects cannot be carried out.)
4. Click OK after completing the settings on the slide show.
5. From the tree-view, select the folder where images are stored.
6. Using the viewing area, rearrange the images in order of display sequence.
7. While making the selection for the required images, hold down the Ctrl key.
8. From the File menu, click Save as Slide Show.
9. Before saving the created slide show, confirm the settings again. Click OK to save the file.

* For PictureGear Version 4.0 and later
1. Start PictureGear.
2. From the tree-view, select the folder where images are stored in.
3. Using the viewing area, rearrange the images in order of display sequence.
4. While making the selection for the required images, hold down the Ctrl key.
5. From the File menu, click Save as Slide Show.
6. Before saving the created slide show, click Settings.. to set the effect on the slide show. Click OK to save the file.

Note: The created file can be used to run the slide show on other computers where PictureGear is not installed. However, due to the specification of some computers, the slide show cannot be played back sometimes.